#Vcds 12.12 connection problems install
#Vcds 12.12 connection problems manual
#Vcds 12.12 connection problems upgrade

Generally this types of cables (i speak here only about the HW and not about the modified SW) without GAL and without bus transceivers works good on OBD protocol but can be instables on KKL. The experiences with this construction that it can be produce often communication errors when K-Lines are used. As i can see this one has Atmega 162, MCP2515, FT232RL, L7805CV (5v regulator).Īnother disadvantage of your cable (additionally what Matty said yet) that the SI9241-AEY bus transceivers on the 2 k-lines are replaced with transitors. Is this one reflashable and fixable? Thank you very much and i will post some photos of my tool right here. Mostly i would like to know if i can easily brick this unit if connected to internet or not.

#Vcds 12.12 connection problems manual

In the software manual it says that i have to turn back computer time to 2013 and also i need to disconnect internet.

I also ordered Chinese version of VCDS 12.12.0 and i would like to know if this is a bad unit or what i can do with it.

#Vcds 12.12 connection problems install

To be sure that you'll not have any problem you can install the software in computer that will haven't any internet connection turned on ever.Ĭhinese do not make tools with not banned serial anb with internet protection becasue they will not sell their stuff anymore in very short time.Īnd the tools that cannot be erased are not made in china and not cheap. The serial in this tool it was banned for a long time 9 actually imediatlly when the clones of this version was released. It can change the licese in the software and when you'll plugg the tool even you'll have the internet connection turned on your license will be erased. The ross-tech servers can check you license when you have the internet connection turned on and the VCDS software installed and activated in your computer even you haven t the tool plugged to the USB and car. I can say that you need to not turn on the internet in that computer ever. So in this case you can erase the license from Atmega Sometimes there are 2 codes 1 for adaptations and another for coding. Hover over the entry box and if there is a known code a bubble should show it. For security access go to the module and click on security. If connected to obd port fully you should get positives for all of the K values. Simply drive the car over 10 kms/hr (or about 6mph in your s.

#Vcds 12.12 connection problems upgrade

To change the computer back it is because now will appear when start the software the message the anounce you that there's a new version released and you can try to upgrade it. When you first load vcds go to options and test the lead. Find Presentation mode and set to active (default is 'not active ') To turn 'showroom' mode off. VCDS 12.12.0 it is a release version and for this software you do not need to change the computer date bacause it hasn't a time limit as Beta's version The software you said that it is teh one that it is using a bat file that will remaind you to turn the internet connection off and change the computer date This is a hardware without GAL/ATF ( no dual k-line supported but maybe this is not a problem )